Camaro U Joint Size

What you most likely have is a 1310 series u-joint from the 10 bolt and the 12 bolt uses the larger 1330 series.

Camaro u joint size. So you could just swap the rear end yokes. U-bolts are just that u shaped bolts and the rear yoke is not threaded. All 1969 Camaro driveshafts are 4956 inches in length.

I believe the the driveshaft side uses a 1310 u joint that is about 3 14 inches wide. The u-bolts slide right though the yoke and nuts are applied to the u-bolts. Same size on the driveshaft side bigger on the rear yoke side.

This driveshaft is made from 35 Aluminum with solid u-joints a Billet transmission yoke and a 1350 series rear u-joint. Straps are for threaded yokes which was the case in my new used. 1993-2002 CamaroFirebird V8 for Moser 9 Conversion 1350 3-12 Aluminum Driveshaft.

Once you found your desired part number you. Keep in mind that your Camaro may have any combination of u-joint sizes so please dont assume anything. There is a u joint available with 1310 on one side and 13301350 on the other.

Show Only This Year. Please measure your u-joint width before ordering. COMBINATION U-JOINTS may have been used at the rear end of some INSIDE C clip style OEM driveshafts.

After you find the correct style use the depiction of the selected style once again to find the measurements of your u-joint. Use the the link provided to identify your u-joint series. 8 Mar 2 2005.